A family of poles from rationalist design. TETRA PARCO is a small light architectural structure: the body with a square section is composed of two separate volumes by two uprights supporting the light source. At power-on, this ephemeral structure disappears from sight, transforming into two beams of geometrical light which creates a suggestive alternation of light and shadow on the floor. TETRA PARCO is an efficient tool for the lighting of open spaces, pedestrian areas and urban zones.
Extruded aluminium alloy body and side shoulders. Die-cast head and flange manufactured in aluminium alloy EN 44300 with very low copper content and aluminium alloy ground fixing flange. Fully concealed ground fixing flange. As an alternative to the traditional polycarbonate (PC),used with diffusers to seal the lamp polymethylmethacrylate (PMMA) is used , so we obtain characteristics of high transparency, UV resistance and scratch resistance. A4 Stainless steel screws. Subjected to galvanic anodizing treatment divided into distinct phases: mechanical satin finishing, surface degreasing, anodic oxidation and final sealing. The product is painted following a continuous two step paint process (epoxy-based primer + polyester-based colour finish), which allows to generate a single thick protective coating which then generates aprotective barrier against atmospheric agents and UV rays. Before fixing the diffuser on the Platek products a Pre-treatment using an atmospheric pressure plasma process is carried out on the surface. The process activates the ionic load on the surface exactly where it is needed, thus promoting the best silicone grip possible and removing any residual release of agents for a longer lasting seal. The next steps are the coating of silicone and the assembly of the diffuser on the lighting fixture, with an automated process to guarantee the perfect sealing of the lamp.
